Driving Belt: 8" wide black PVC belt for 15" & 21" between frame, 12" wide belt for 27" between frame.
Bed: 7" x 1-1/2" x 12 gauge powder painted formed steel channel. Bed sections are 5' and 10' long bolted together with butt plates and floor supports.
Tread Rollers: 1.9" diameter x 16 gauge galvanized steel rollers spaced on 2-1/4", 3", 4-1/2" or 6" on centers. Equipped with safety pop-out design to prevent damage to product or harm to personnel if caught between drive belt and tread rollers.
Pressure Rollers: 1.9" diameter x 16 gauge galvanized steel rollers spaced on 6", 9", or 12" centers and equipped with pressure adjustable cams.
X-Bracing: Frame squaring device supplied with conveyors over 40' long on every other bed section.
Drive Pulley: 8" diameter drive pulley crowned and fully lagged with 1-7/16" shaft. Located in center drive.
|
Return Idler: 1.9" diameter adjustable on 10' centers.
Tail Pulley: 4" diameter crowned with 1-3/16" shaft, located at each end of conveyor.
Snub Rollers: 2-1/2" diameter adjustable, located directly behind drive pulley. 2" diameter at each end directly behind tail pulleys.
Floor Supports: Adjustable from 31-1/2" to 45-1/2", measured from floor to top of roller. Each conveyor supplied with one support at each end and one support at each bed joint.
Take-Up: Located in the center drive, provides 24" of belt take-up.
Bearings: Sealed and prelubricated with cast iron housing.
Motor: 1/2 HP 230-460-3-60 totally enclosed.
Belt Speed: 60 feet per minute, constant speed.
Finish: Green Powder Coat Finish.
|
